Home > Forum > Interface converters > ATC-1200 Ethernet / serial converter configuration
- This topic has 0 replies, 1 participant and was last updated 6 years ago da Sergio Bertana.
-
AuthorPost
-
April 11, 2018 at 6: 58 am #36197Sergio BertanaAdministrator Forum
The ATC-1200 ethernet / serial converter is supplied configured by default with the 192.168.2.125 IP address, so to configure it, you must assign a static IP address to your PC, mapping it to the default device address (Example 192.168.2.10).
Once the IP address has been assigned to your PC, you can open the converter's web page from the browser (Chrome Example) by typing in the address of the 192.168.2.125 itself. The page with the request for access credentials will be displayed, type as Username admin and how Password admin. Once logged in, the configuration pages will be displayed and at the top it will be possible to browse the various pages, I refer you to Knowledge related to product configuration.
Return the converter to Factory Default settings If you forget the configuration made on the module (so also its IP address) you can put it back in its default configuration (with 192.168.2.125 IP address) by following these notes. Locate the reset button in the side louver of the product (GALLERY): a) Supply the module. b) Press and hold the button for 5 seconds. c) Release the button. d) Turn off the module.
-
AuthorPost
- You must be logged in to reply to this topic.